PTP 550 Integrado

PTP 550 Integrado

C050055H011A
683,46 €
Impuestos excluidos ¡envío en 24/48H!
826,99 € Impuestos incluídos

Punto a punto Gigabit + Capacidad. PTP 550 proporciona un rendimiento de hasta 1,36 Gbps con ARQ y agregación de canales asimétrica no contigua en la banda de 5 GHz. El PTP 550 presenta la selección de canales dinámicos (DCS), la agregación de operadores y la capacidad de 1,4 Gbit.

PTP 550 es una solución de rendimiento Gigabit de punto a punto basada en 802.11ac Wave 2 que opera en un espacio inalámbrico de 5 GHz, que aborda las necesidades de capacidad de gigabit para soluciones de backhaul de alta velocidad en aplicaciones de corto y medio alcance que proporciona un rendimiento de hasta 1.36 Gbps con ARQ y asimétrica agregación de canales no contiguos en la banda de 5 GHz. La solución PTP 550 extrae sus atributos de los productos punto a punto de Cambium Networks, como PTP 650/670 y PTP 450i. Cada radio PTP 550 está encerrada en una carcasa de metal resistente con clasificación IP66 / 67, que protege la radio de condiciones extremas y radiación solar.
PRODUCT  
Model/Part# See table below for full set of Model and Part Numbers
SPECTRUM  
Channel Spacing Configurable on 5 MHz increments
Frequency Range 5150 - 5970 MHz (exact frequencies as allowed by local regulations) 
Channel Width 5 I 10 I 20 I 40 MHz
INTERFACE  
MAC (Media Access Control) Layer Cambium proprietary and optionally standard 802.lln
Physical Layer 2x2 MIMO/OFDM
Ethernet Interfaced 100/lOOOBaseT, rate auto negotiated, 802.3at compliant
Powering Methods Supported 56 V PoE (included), standard 802.3at PoE Supply, or CMM4 with 56 V and 5 pin to 7 pin cross over cable adapter
Protocols Used IPv4/IPv6 (Dual Stack), UDP, TCP, ICMP, SNMPv2c, NTP, STP, IGMP, SSH
Network Management IPv4/IPv6, HTTPs, SNMPv2c, SSH, Cambium Networks CnMaestro™
VLAN 802.lQ with 802.lp priority
PERFORMANCE  
Subscribers per Sector Up to 120; Lite version limited to 10
ARQ Yes
Nominal Receive Sensitivity (w/FEC) @20MHz Channel MCSO = -93 dBm to MCS15 = -69 dBm (per branch)
Nominal Receive Sensitivity (w/FEC) @40MHz Channel MCSO = -90 dBm to MCS15 = -66 dBm (per branch)
Modulation Levels (Adaptive) MCSO (BPSK) to MCS15 (640AM 5/6)
GPS Synchronization Yes, via internal GPS or CMM4 with 56 V and 5 pin to 7 pin cross over cable adapter
Quality of Service Three-level priority (Voice, High, Low) with packet classification by DSCP, COS, VLAN ID, IP & MAC Address, Broadcast, Multicast, 
and Station Priority
Transmit Power Range 0 to +30 dBm (combined, to regional EIRP limit) (1 dB interval)
RECOMMENDED ANTENNAS  
Sector Antenna ePMP Sector Antenna (C050900D021A) available
ePMP 2000 Smart Antenna ePMP 2000 Smart Antenna (C050900D020A) available (complimentary; does not replace Sector Antenna)
PHYSICAL  
Sector Antenna Connection 2 x 50 ohm, RP (reverse polarity) SMA
Beamforming Antenna Connection 2 x 50 ohm, RP (reverse polarity) SMA, DC coupled (powering antenna)
GPS Antenna Connection 1 x 50 ohm, RP (reverse polarity) SMA
Surge Suppression 1 Joule Integrated
Environmental IP55
Temperature -30°C to +55°C (-22°F to +131°F)
Power Consumption 20 W Maximum [1]
Input Voltage 44 V to 59 V
Weight 0.7 kg (1.54 lbs.) without brackets
Dimensions 125 x 210 x 37 mm (4.9 x 8.3 x 1.5 in.) without brackets
Pole Mount Included Yes
Environmental Cover Included Yes
SECURITY  
Encryption 128 bit AES (CCMP mode)
CERTIFICATIONS  
FCCID Z8H80FT0020
Industry Canada Cert 109W-0020
CE

EN 301 893 V2.1.1  

EN 302 502 V2.1.1

Notes:
[1] The maximum power consumption of the Access Point is the same regardless of whether the optional Smart
Beamforming Antenna is equipped or not. This is because the Beamforming Antenna draws its power during the uplink
cycle when the Access Point power consumption is not at its maxium.

Artículos relacionados